How to "turn on" IPv6 Tunnel

[rromero]

Hi,

I just started my certification path today, Im very new at this so Im asking for your help.

I did register, got into Tunnelbroker, did the tunnel configuration and got stuck.

I read this post: http://www.tunnelbroker.net/forums/index.php?topic=1088.0 , where I think he had a similar problem, but then, almost at final, the post says "configure an IPv6 address at Control Panel just as IPv4", right, I got into the IPv6 properties and it is asking me, IP address, mask,  default gateway (IPv6 of course) and DNS primary and secondary.

Anyone knows where can I get that info from?

What Im missing here?

My last configuration (Im almost behind a NAT).

netsh interface teredo set state disabled
netsh interface ipv6 add v6v4tunnel IP6Tunnel 192.168.1.106 66.220.18.42
netsh interface ipv6 add address IP6Tunnel 2001:470:c:377::2
netsh interface ipv6 add route ::/0 IP6Tunnel 2001:470:c:377::1



Please advice.

Thank you very much

Regards,

[cholzhauer]

On your tunnel info page, there will be a line that says "routed 64". Pick any address from that range and use it as the address on your adapter

The mask is /64

The gateway address is the inside interface of your router.  If you're assigning the ipv6 address to your router, then the default gateway is the HE side of the tunnel

[rromero]

Thank you, I got:

2001:470:d:377::/64

Any suggestions? Like 2001:470:cccc:377::/64 ?

I have not configured router (provided by ISP), it is a DSL Huawei router, must I?

What about DNS?

Regards

[rromero]

Help!!

The default gateway (DSL router) has no support for IPv6!!!

Any suggestions?

Regards,

[rromero]

Thanks, maybe I didnt explain well myself:

1. Im on a Laptop running Windows 7-64bit
2. Im behind a DSL connection, I have one 192.168.1.x address
3. I got into the TunnelBroker and generate tunnel according to instructions, when generating it showed me a public IP 184.x.x.x
4. Selected OS and have the commands
5. Input the commands, changing the source IP address 184.x.x.x to 192.168.1.x

At this point, I understood the Tunnel was created, but I verified and it has not.

6. I investigated and says somewhere the forum I have to manually change the IPv6 address (please give me a hint with above info, I realized I done it wrong).
7. But then, I need a "default gateway" and IPv6 DNS.

The questions are:

1. Is this a must?
2. How or what parameters must be entered? My laptop is the only IPv6 device I got.

Please help, I can not start certification without the tunnel.

Thank you very much

Best Regards