IP6 on Windows 2008 64-bit

[chuacw]

Hi all,

I got my IP6 tunnel on Windows 2008 64-bit to work SUCCESSFULLY.
I am REPORTING SUCCESS, NOT SAYING IT DOES'T WORK.

I am behind a NAT.

I ran the "Create Regular Tunnel" link, and entered my NAT address into the Client IPv4 address field. This gave me a red warning "IP is blocked. (RFC1918 Private Address Space)" which I ignored.

Here's my configuration.

1) IPv6 is NOT enabled on my physical adapter
2) My NAT address is xxx

I ran the commands accordingly,

netsh interface teredo set state disabled
netsh interface ipv6 add v6v4tunnel IP6Tunnel xxx ServerIPv4
netsh interface ipv6 add address IP6Tunnel ClientIPv6
netsh interface ipv6 add route ::/0 IP6Tunnel ServerIPv6

Where ServerIPv4 is the server's IPv4 address
ClientIPv6 is the client's IPv6 address