Hey everyone. I'm pretty new to ipv6. I have a tunnel and /48 network allocated here and am using the tunnel successfully from my debian linux box in a co-location that has no ipv6 support.
The box is not directly connected to any of my other networks.
I would like to make my debian box act as a secondary tunnel for my office system which is sitting behind a linksys wrt54g flashed with dd-wrt.
when I type ifconfig I see the following for sit0 and sit1:
sit0 Link encap:IPv6-in-IPv4
inet6 addr: ::126.96.36.199/96 Scope:Compat
inet6 addr: ::127.0.0.1/96 Scope:Unknown
inet6 addr: ::188.8.131.52/96 Scope:Compat
inet6 addr: ::184.108.40.206/96 Scope:Compat
UP RUNNING NOARP MTU:1480 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
sit1 Link encap:IPv6-in-IPv4
inet6 addr: 2001:470:1f04:378::2/64 Scope:Global
inet6 addr: fe80::d161:c6fa/64 Scope:Link
inet6 addr: fe80::d161:cb9b/64 Scope:Link
inet6 addr: fe80::d161:cb9a/64 Scope:Link
UP POINTOPOINT RUNNING NOARP MTU:1480 Metric:1
RX packets:2011 errors:0 dropped:0 overruns:0 frame:0
TX packets:2005 errors:0 dropped:0 overruns:0 carrier:0
RX bytes:376029 (367.2 KiB) TX bytes:1591521 (1.5 MiB)
I am guessing that I would need to:
* create a sit2 and sit3 on my server to be the tunnel endpoint
* enable ipv6 forwarding
* set the appropriate route entries
Then I would have to set up my linksys router to connect to this new tunnel endpoint. The linksys router would also run radvd with the appropriate parameters so that all my computers in the office can just use ipv6 directly - their ipv6 packets would get routed through linksys, tunnel to my server, then tunneled to HE.NET.
Is this reasonable? Where do I get started to learn about creating this configuration?